Manage stand orders
Select Option

Thermal Engineering srl

Via Giove, 10, 36055 Nove (VI)
Italy
Telephone +39 0424 829493
Fax +39 0424 829980
info@te-italy.com

Hall map

THERMPROCESS 2019 hall map (Hall 9): stand A55

Fairground map

THERMPROCESS 2019 fairground map: Hall 9

Our range of products

Product categories

  • 01  Industrial Furnaces, Industrial Heat Treatment Plants and thermal processes for
  • 01.08  Steel and Iron
  • 01.08.03  Heat treating
  • 01.08.03.01  Heating

Our products

Product category: Heating

BELL TYPE FURNACES

Bell Annealing is a type of annealing that derives its name from the shape of the furnace used during the process. Bell Annealing heats batches of metal which are placed on a base assembly, enclosed by an inner cover, and covered by the furnace. An overhead crane is used to load the base and move the equipment—when the furnace is suspended from the crane, it looks like a bell. The base assembly is the source of convection and the main method of heat transfer to the charge. The inner cover seals in the desired atmosphere and protects the charge from the burners’ direct heat. Keeping contaminants out of the annealing atmosphere prevents chemical changes as well as eliminating the formation of oxides and soot on the metal. The furnace brings the charge to the desired temperature to allow for the metallurgical changes to occur. Direct fired, tangentially fired, radiant tube, and electrical resistance are furnace types related to the method used to heat the charge. After heat treatment, cooling is performed by removing the furnace-leaving the inner cover in place to maintain the protective atmosphere. If a bright finish is desired, the metal must be cooled to near ambient temperature before exposing the metal to air. In this case, another piece of equipmentis utilized: a forced-cooler. The forced-cooler replaces the furnace at the end of the heating cycle and uses air and sometimes spray water to accelerate the cooling of the outside of the inner cover.

The main advantages of a Bell-Type annealing furnace are:
• Consistent product quality
• Good production rates
• Low operating costs
• Efficient use of furnace asset by cooling
with inner cover
• Savings in shop floor space requiring less capital
investment and reducing material handling

Bell furnaces are used to anneal both strip and wire coils. Furnaces designed for strip are generally of a single-stack configuration. The base diameter accommodates on coil centered over the base fan. The strip coils are stacked on top of one another, separated by convector plates. The circulated atmosphere flows up the sides and back down to the fan through the center of the coil.
To anneal wire, the coils must first be placed on a carrier, which is then loaded onto the annealing base. Furnaces designed for wire are generally of a multi-stack configuration. This requires a larger base, making the wire annealing furnaces short and wide compared to the strip counterparts. Like a strip furnace, the convection flow goes up on the sides and down the center. For multi-stack wire systems, a plenum is used above the diffuser to direct all the flow to the inner cover wall and provide a return path for flow to the large convection fan.

More Less

About us

Company details

The know-how of Thermal Engineering began in 1984, with the artisanal production of heat exchangers. From the heat exchangers the factory migrated to what was the most prosperous market of the 90s in the area of Bassano, and began to build kilns for ceramics. Ceramic furnaces had immediately a great success, thanks to the energy saving given by the use of heat exchangers, already very improved, and flame preheaters. Soon, the great majority of the pottery in the area chose Thermal Engineering.

More Less